Aries-automotive 7010 Manual de usuario descargar pdf

INSTALLATION INSTRUCTIONS

FRONT BAR PART #7010

2001-05 HYUNDAI SANTA FE

PARTS LIST

1- FRONT BAR 4- M8 FLAT WASHERS

4- M8 LOCK WASHERS 2- ¼ X ¾ SCREWS

2- ¼ HEX NUTS 2- FRAME MOUNTING BRACKETS

2- TOP MOUNTING BRACKETS 6- 7/16 X 1 ¼ HEX BOLTS

6- 7/16 X 1 1/4 HEX BOLTS 12- 7/16 FLAT WASHERS

4- M8 X 30 MM HEX BOLTS 2- 5/16 X ¾ HEX BOLTS

2- 5/16 HEX NUTS 2- NUT PLATES

INSTALLING FRONT BAR FOR 2001-03 MODEL

1. Remove existing bolts from bottom of frame rail

2. Using the M8 x 30 MM hex bolts, M8 flat washers, and M8 lock washers, attach passenger and driver

side frame brackets to bottom of the frame rail. (Note that one hole on each bracket will not be used for

this installation, so do not be alarmed to see an vacant hole. Use the one oval and round hole on

bracket). Leave Loose.

3. Open hood to expose plastic trim rivets along bumper flange.

4. Locate and remove the plastic rivets from the head light area.

5. Attach top brackets to bumper the flange using the 5/16 x ¾ hex bolts and 5/16 hex nuts. Do not

secure.

6. Attach the front bar assembly to the outside of lower frame brackets using 7/16 x 1 ¼ hex bolts, 7/16

hex nuts and 7/16 flat washers and the center to top brackets using ¼ x ¾ screws and ¼ hex nuts. Do

not secure.

7. Align front bar assembly with front of the vehicle and secure all bolts and nuts.

FIGURE A

1 2 3

Pagina 1

INSTALLATION INSTRUCTIONS FRONT BAR PART #7010 2001-05 HYUNDAI SANTA FE PARTS LIST 1- FRONT BAR 4- M8 FLAT WASHERS 4- M8 LOCK WASHERS 2

INSTALLING FRONT BAR FOR 2004-05 MODEL 1. Locate bottom frame rail holes where grill/brush guard brackets are to be attached. The skid plate will

FIGURE 3 FIGURE 4 - HOOD OPEN –RIVETS NEED TO BE REMOVED FIGURE 5- HOOD OPEN – AFTER TOP BRACKET POINTS

Sin comentarios

Aries-automotive 7010 Manual de usuario